Prepare Surface

• Apply 2 layers of weather resistive barrier to the sheathing surface.
• Apply metal lath over the weather resistive barrier.
• Apply ½" scratch coat of type N or S mortar or pre-mix mortar specified for stone veneer use over metal lath.
• Allow scratch coat to dry for 24-48 hours.

Install Stone

• Install corners first, then flats.
• Gently wet the scratch coat and stone veneer.
• Apply approximately ½" thick mortar
  to back of stone.
• Place stone onto scratch coat.
• Gently wiggle piece into place.
• Do not smear or wipe mortar onto the face of the stone
• Do not remove any excess mortar on the face of the stone when mortar is wet. Allow it to dry and use a soft bristle brush to remove.
• Do not use acid wash or bleach
  based cleaners on StoneCraft.

Apply Grout

• Grout as needed using a type N or S mortar mix.
• Use grout bag and fill areas where scratch coat may be exposed.
• Strike joints after grout is thumbprint dry.
• Whisk away loose mortar.